Prove the Electrolyser, Cell by Cell.

An electrolyser's efficiency, purity, durability and how well it responds to a swinging renewable power supply are the numbers a whole hydrogen plant gets designed around. You don't take those numbers on a datasheet — you measure them, under controlled and repeatable conditions, before the stack is trusted with a project. That's what Neometrix's electrolyser test station does: programmable DC, deionised water, thermal control and back-pressure go in; polarisation curves, efficiency, hydrogen/oxygen crossover, per-cell voltage, electrochemical impedance spectroscopy and durability data come out — across PEM, AEM or alkaline chemistries, from single-cell to full-stack.

A Fair Test Needs Controlled Inputs

To grade a stack honestly, you have to give it clean, precise DC power, deionised water at a set temperature and flow, and controlled back-pressure. The station is as much a precision inputs-provider as it is a measurement rig, because a sloppy input makes an honest output number impossible. Programmable DC can hold steady or ramp to simulate the kind of variable, renewable-fed supply the stack will actually see in service.

Crossover Is the Safety-Critical Measurement

Hydrogen crossing into the oxygen stream — or oxygen into the hydrogen stream — toward the flammable limit is both a performance metric and a real hazard. That's why continuous crossover monitoring with lower-flammability-limit trips is built into the station as a core feature, not an optional extra bolted on for compliance.

Per-Cell Voltage Finds the Weak Cell

A stack is a series of individual cells. One degrading cell drags down — and can eventually take down — the entire stack. Per-cell voltage monitoring is the diagnostic that a plain power supply and flowmeter simply cannot give you; it's the difference between knowing a stack's aggregate performance and knowing exactly which cell is failing.

Prove the Stack, Then Build Around It

The station measures precisely the numbers a green hydrogen generation plant is designed from: efficiency, purity, dynamic response. Test the stack here, then engineer the plant on real measured data rather than a manufacturer's brochure figure. The two workflows — testing and plant design — are one continuous discipline at Neometrix, not separate businesses.

Three Disciplines in One Rig

A programmable DC source, a safe hydrogen/oxygen gas-handling system, and an electrochemical workstation come together in one station — test-bench, gas-handling and controls competence Neometrix already has, combined with a bought-in potentiostat/EIS instrument for the electrochemical measurement itself.

We Integrate; the Instruments Are Specialist

The DC supply, mass-flow controllers, gas analysers and the electrochemical workstation are bought-in specialist instruments. Neometrix engineers the station around them: fluidics, thermal management, gas handling, test fixturing, safety systems, controls and test protocols. No specific delivered station is claimed on this page — this describes a reference station engineered to order.

Frequently Asked Questions

Why is gas crossover monitored so carefully during electrolyser testing?
Because hydrogen crossing into the oxygen stream (or vice versa) is simultaneously a performance indicator and a genuine explosion hazard if it approaches the lower flammability limit. A durability test can run for many hours or days, so continuous, automatically interlocked crossover monitoring isn't a compliance checkbox — it's what keeps a routine long-duration test from becoming an oxy-hydrogen safety incident.

What can per-cell voltage monitoring tell you that overall stack voltage can't?
An electrolyser stack is built from many individual cells connected in series, and stack-level measurements only show you the average behaviour across all of them. If one cell starts degrading, its rising voltage gets averaged out and hidden in the total — until it eventually drags down or damages the whole stack. Per-cell monitoring catches that one weak cell early, while a plain power supply and flowmeter reading only the aggregate output would miss it entirely.