Preparing Your Burnaby Roof for Winter Storms and Hail

If you've lived in Burnaby for more than a few winters, you know the drill. The rain starts in October and doesn't really let up until April. But what many homeowners don't realize is that winter in Burnaby isn't just about rain—it's about wind, occasional snow, and increasingly, hailstorms that can damage roofs in minutes.

In 2024 alone, BC Hydro logged 1.4 million weather-related outages province-wide, its highest on record . That same year, a November storm fired marble-sized hail across Burnaby within minutes of landfall . The message is clear: Burnaby roofs face more than just persistent drizzle.

This guide walks you through practical steps to prepare your roof for winter's worst, from simple gutter cleaning to material upgrades that make a real difference.

Understanding What Your Roof Faces

Burnaby sits in BC Building Code Climate Zone 4, where the minimum design snow load hovers around 1.9 kPa . But that's just the baseline. Drifts along multi-level roofs can triple that figure, and coastal snow absorbs rain, pushing weight far beyond the code's base map .

The local threats include:

• Freeze-thaw cycles: Burnaby endures roughly 38 freeze-thaw cycles per year—conditions that crack asphalt shingles and trap moisture
• Wind-driven rain: Winter gusts can exceed 60 km/h, enough to flutter ridge caps and lift shingles
• Coastal salt air: Salt spray carried on storm winds can degrade steel roofing within years
• Snow accumulation: When powder reaches boot-laces, shovel; when it slumps like oatmeal, shovel twice as soon

For homeowners in older Burnaby neighborhoods like Capitol Hill or Deer Lake, these threats are amplified by aging materials and complex roof geometries.

The Pre-Winter Checklist

1. Clear Every Drainage Path

Gutters in the Lower Mainland collect moss faster than leaves . When moss mats constrict spouts, meltwater backs beneath shingle courses, refreezes overnight, and slowly pries plywood apart.

What to do:

• Clear gutters, downspouts, and scuppers in October
• Repeat after the first major storm
• Consider upsizing to 3 × 4-inch downpipes—an upgrade that cuts overflow calls by half

2. Inspect Like a Detective

A cursory glance from the sidewalk will not reveal the blister hidden under a shingle tab or the loosened ring-shank nail that's about to lift during the next gusty night .

Where to look:

• Start in the attic—look for daylight pinholes, lingering frost, and damp insulation
• Examine valley metal—hail loves to bruise thin gauges
• Check chimney crickets, which often trap snow then leak during a chinook

3. Upgrade Your Shingles

If your roof needs replacing, consider Class 4 impact-rated shingles. These use SBS modifiers that flex in cold snaps, resisting split edges and hail pocks . Standard three-tab shingles simply cannot handle the combination of winter storms and freeze-thaw cycles that Burnaby delivers.

Other material considerations:

• Ice-and-water membrane along eaves is mandatory—self-sealing bitumen halves leak risk during wind-driven rain events
• Synthetic underlayment outperforms traditional felt in wet conditions
• Standing-seam metal sheds snow cleanly and shrugs off hail without dimpling

4. Check Your Flashings

Caulk is confession that metal was cut short . Proper flashing installation prevents leaks where the roof meets chimneys, vents, and skylights.

What professionals check:

• Continuous step flashing with kick-outs extending two inches past siding
• Hemmed fascia flashings tight to stop "huge gaps"
• Counter-flashing on chimneys laced two courses high into the brick

5. Secure Your Fasteners

Switching from galvanized staples to ring-shank nails might seem trivial until you learn that uplift forces double at 70 km/h gusts—the norm in a bomb cyclone .

Key upgrades:

• Stainless screws on metal roofs
• Gasketed neoprene washers on exposed-fastener panels
• Stainless clout nails on flashing edges

6. Let Your Roof Breathe

A Burnaby attic wants roughly 1 sq ft of net free vent per 300 sq ft of attic floor . Proper ventilation prevents moisture buildup that leads to mold, rot, and premature shingle failure.

For homeowners who want professional guidance, qualified roofing specialists can provide a comprehensive inspection that catches issues before winter storms arrive.

The Cost of Neglect

The economics of preparation are compelling. Consider these real numbers:

Cut corners here and warranties evaporate. Many manufacturer warranties stipulate documented inspections as a condition of claim approval—fine print easy to miss until hail the size of golf balls starts quoting it back to you .

Conclusion

Burnaby's winters are getting more extreme, and your roof is the only thing standing between your family and the elements. A fall inspection, proper drainage, impact-rated materials, and secure fasteners are your best defense. Take action now, before the first winter storm arrives. Your home—and your wallet—will thank you.

Frequently Asked Questions

1. When should I prepare my roof for winter in Burnaby?

Book a fall inspection between late September and late October—before the first atmospheric river arrives. Clear gutters and check flashing before the heavy rain begins .

2. How does hail damage roofs in Burnaby?

Hailstones accelerated by outflow winds can bruise thin metal valleys, crack aging shingles, and pock-mark panels. Class 4 impact shingles provide the best protection .

3. What's the best material for Burnaby winter conditions?

Standing-seam metal sheds snow cleanly, handles freeze-thaw cycles well, and shrugs off hail damage. For asphalt, choose architectural laminates with SBS modifiers and Class 4 impact rating .

4. Why is attic insulation important for winter?

Proper insulation and ventilation prevent ice dams—when snow melts and refreezes at the roof edge, water can back up under shingles and into your home .

5. How often should I inspect my roof during winter?

After any storm with wind gusts above 60 km/h, heavy snowfall, or ice accumulation. Use binoculars for a ground-level check of lifted tabs or damaged flashing .

6. Should I remove snow from my roof?

Yes. If snow accumulates beyond 15 cm, consider careful removal to prevent structural strain. Wet coastal snow is heavier than dry powder and can stress roof assemblies . For professional assistance, contact experienced contractors who can safely handle snow removal and storm damage inspections.