- Clean Your Camera Thoroughly Start by wiping your camera body with a microfiber cloth. Remove dust, oil, and fingerprints—even tiny particles can cause bubbles.
👉 Tip: Use a little isopropyl alcohol for a perfect clean surface.
Test Fit Before Peeling
Place each skin piece on the camera without removing the adhesive backing.
This helps you understand alignment and placement.Start with One Section
Peel a small portion of the backing (don’t remove all at once).
Carefully align it with buttons, edges, or logo areas.
- Apply Slowly & Evenly
Press the skin gently from one side to the other.
Use your fingers or a soft card to smooth it out as you go.
👉 Move slowly to avoid air bubbles.
- Use Heat for Perfect Finish
Use a hairdryer on low heat to slightly warm the skin.
This makes the vinyl more flexible and helps it stick better—especially on curves.
- Press & Seal Edges
After applying, press firmly around edges and corners.
This ensures long-lasting adhesion.
- Fix Bubbles (If Any)
If you see small bubbles:
Push them toward the edge
Or gently lift and reapply
Tiny bubbles usually disappear over time
