Playwright in Pictures: Fully Parallel Mode

Playwright in Pictures is a series of articles where I use playwright-timeline-reporter to explain different Playwright concepts with simple timeline charts. Here's the first article in the series.

Playwright’s fullyParallel mode is often treated as a simple performance switch. In practice, it changes how the runner schedules work, which leads to different execution shapes for the same test suite.

In this post I’ll show a visual comparison of different modes and highlight when fully parallel is slower.

Example Setup

I use a minimal suite:

• spec1.test.ts → 1 test
• spec2.test.ts → 5 tests
• workers = 2

This setup is enough to expose how scheduling works.

Non-Fully Parallel

By default, Playwright assigns entire files to workers. Once a worker picks a file, it runs all tests in that file in order.

Running the example suite:

npx playwright test --workers 2

produces the following timeline:

In this setup, Worker 1 runs the single test from spec1, while Worker 2 executes all 5 tests from spec2.

Tests inside a file cannot move to another worker. Even if one worker is idle, it cannot pick up remaining tests from other running files.

In practice, the total run time is defined by the longest file, not by the total amount of work.

Fully Parallel

With --fully-parallel enabled, Playwright schedules individual tests instead of files. File boundaries stop mattering. Workers take the next available test.

Running the example suite with --fully-parallel:

npx playwright test --workers 2 --fully-parallel

The timeline:

With the same setup, the 5 tests from spec2 are split across both workers, keeping the timeline balanced.

The total run time drops from 5.6s to 3.5s.

This shifts the execution model. It now follows individual tests instead of the longest file.

Is Fully Parallel Always Faster? No.

Fully parallel mode may be slower if tests rely on heavy worker hooks or worker fixtures.

To illustrate this, I added a heavy beforeAll hook to spec2:

test.beforeAll(async () => {
  await expensiveSetup()
});

Running the tests without fully parallel:

The beforeAll setup cost (yellow bar) is paid once in Worker 2 and reused across all tests in that file.

Now run the same suite with --fully-parallel:

Here, beforeAll runs twice, once per worker. As the number of workers grows, the setup is repeated more times.

Total run time increases from 15s to 20s after enabling fully parallel mode.

When setup dominates test time, --fully-parallel makes the run slower.

Key Takeaways

• By default, Playwright runs tests per file: files are split across workers, tests inside a file run sequentially.
• With fully parallel mode, tests are split across workers and run independently.
• Fully parallel mode can slow tests down. Check your test distribution and setup before enabling it.